LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2006 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions >> Input Carrier Inspection and Installation

Input Carrier Inspection and Installation

    Fig 1: View Of Input Carrier Captive Thrust Bearing Assembly
    GM5463Courtesy of GENERAL MOTORS CORP.
  1. Inspect the input carrier captive thrust bearing assembly. To check the captive thrust bearing in the input carrier (662) for wear, place a bushing or an output shaft sleeve (690) onto the bearing race and turn it with the palm of your hand. Do not touch the pinion gears. Any imperfections will be felt through the bushing.
    2. Fig 2: Input Carrier Assembly & Output Shaft
    GM1265873Courtesy of GENERAL MOTORS CORP.
  2. Install the input carrier assembly (662) onto the output shaft.
    3. Fig 3: View Of Output Shaft To Input Carrier Retainer
    GM13271Courtesy of GENERAL MOTORS CORP.
    IMPORTANT:
    • Do not reuse the old output shaft to input carrier retainer (661).
    • Do not over expand the new output shaft to input carrier retainer during installation.
  3. Install a new output shaft to input carrier retainer (661).
    4. Fig 4: Identifying J 29837-A
    GM588767Courtesy of GENERAL MOTORS CORP.
  4. Remove the J 29837-A  . See Special Tools .
scientia non olet · About LEMON Manuals