LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2006 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Steering Gear Worm Gear Adjuster Seal and Stub Shaft Bearing Replacement (700 Gear) >> Disassembly Procedure

Disassembly Procedure

    Fig 1: Using J 43435 To Remove/Install Lock Nut
    GM509348Courtesy of GENERAL MOTORS CORP.
  1. Rotate the stub shaft back and forth in order to drain the power steering fluid.
  2. Remove the coupling shield retainer and the lock nut from the steering gear housing using J 43435  and a torque wrench.
    3. Fig 2: View Of Adjuster Nut Assembly, Steering Gear Housing & J 42882
    GM322012Courtesy of GENERAL MOTORS CORP.
  3. Remove the adjuster nut assembly (2) from the steering gear housing (1) using J 42882  . See Special Tools .
    4. Fig 3: View Of Thrust Support Assembly
    GM322011Courtesy of GENERAL MOTORS CORP.
  4. Remove the thrust support assembly (2) from the steering gear housing (1).
  5. Remove the O-ring seal (3) from the thrust support assembly (2).
scientia non olet · About LEMON Manuals