LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2006 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Steering Gear Worm Gear Adjuster Seal and Stub Shaft Bearing Replacement (700 Gear) >> Assembly Procedure

Assembly Procedure

    Fig 1: View Of Thrust Support Assembly
    GM322011Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Install a new O-ring seal each time the thrust support assembly is removed from the steering gear.
  1. Lubricate the new O-ring seal (3).
  2. Install the new O-ring seal (3) on the thrust support assembly (2).
  3. Install the thrust support assembly (2).
    4. Fig 2: View Of Adjuster Nut Assembly, Steering Gear Housing & J 42882
    GM322012Courtesy of GENERAL MOTORS CORP.
  4. Connect the adjuster nut assembly (2) to the steering gear housing (1) using J 42882  . See Special Tools .
  5. Install the coupling shield retainer and the lock nut (1) to the adjuster nut assembly.
  6. Refer to Steering Gear Worm Gear Thrust Bearing Preload Adjustment - Off Vehicle (700 Gear)  to adjust the thrust bearing preload.
    7. Fig 3: Identifying J 43435 & J 42882
    GM509352Courtesy of GENERAL MOTORS CORP.
  7. Hold the adjuster nut assembly in position to maintain alignment of the marks.
    8. NOTE: Refer to Fastener Notice .
  8. Tighten the coupling shield retainer and the lock nut using J 43435  and a torque wrench.

    Tighten:  Tighten the retainer and the lock nut to 109 N.m (80 lb ft).

scientia non olet · About LEMON Manuals