Antenna Cable Replacement
ANTENNA CABLE REPLACEMENTREMOVAL PROCEDURE
1. Open the hood.
2. Remove the antenna mast boot (1).
3. Remove the antenna mast (2).
4. Remove the 2 screws (3) retaining the front fender upper hole cover.
5. Remove the front fender upper hole cover (4).
6. Remove the 3 screws (1) retaining the mast base.
7. Remove the fastener (2) from the mast base.
8. Remove the right front sill plate.
9. Remove the right kick-up panel.
10. Disconnect the antenna cable (1) from the extension cable (2).
11. Attach a mechanics wire to the antenna cable (1).
12. Remove the antenna cable leaving the mechanics wire in place.
13. Remove the antenna cable assembly from the vehicle.
INSTALLATION PROCEDURE
1. Attach a mechanics wire to the Replacement antenna cable (1).
2. Pull the mechanics wire to route the Replacement antenna cable.
3. Remove the mechanics wire from the antenna cable.
4. Connect the antenna cable (1) to the extension cable (2).
5. Install the right kick-up panel.
6. Install the right front sill plate.
NOTE: Refer to Fastener Notice in Service Precautions.
7. Install the 3 screws (1) retaining the mast base.
Tighten
Tighten the screws to 35 N.m (26 lb ft)
8. Install the fastener (2) to the mast base
9. Install the front fender upper hole cover (4).
10. Install the 2 screws (3) retaining the front tender upper hole cover.
Tighten
Tighten the screws to 2.5 N.m (22 lb in).
11. Install the antenna mast (2).
12. Install the antenna boot (1
13. Close the hood.