Service Specifications
WARNING: This page is about a different car, the 2004 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
DISC BRAKES SPECIFICATIONS
| Applications | In. (mm) | |||
|---|---|---|---|---|
| Front Brakes (1) | ||||
| Rotor Discard Thickness | 1.437 (36.50) | |||
| Rotor Minimum Allowable Thickness After Refinish | 1.457 (37.0) | |||
| Rotor Thickness (NEW) | 1.496 (38.0) | |||
| Rotor Maximum Allowable Assembled Lateral Runout | 0.005 (0.13) | |||
| Rotor Maximum Allowable Scoring | 0.059 (1.50) | |||
| Rotor Maximum Allowable Thickness Variation | 0.001 (0.025) | |||
| Rear Brakes (1) | ||||
| Rotor Discard Thickness | 1.083 (27.50) | |||
| Rotor Minimum Allowable Thickness After Refinish | 1.102 (28.0) | |||
| Rotor Thickness (NEW) | 1.142 (29.0) | |||
| Rotor Maximum Allowable Assembled Lateral Runout | 0.005 (0.13) | |||
| Rotor Maximum Allowable Scoring | 0.059 (1.50) | |||
| Rotor Maximum Allowable Thickness Variation | 0.001 (0.025) | |||
|
||||