LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc Brakes >> Removal & Installation >> Park Brake Shoes >> Installation

Park Brake Shoes: Installation

  1. Clean the debris and the dust from the park brake components using a clean shop cloth. Align the slots in both the adjusting screw and tappet to be parallel with the backing plate face. Install the park brake shoe assembly to the vehicle by placing one of the open ends of the shoe over the axle flange and rotating the shoe until it is behind the flange.
  2. Position the park brake shoe on the inboard side of the actuator. Slide the park brake shoe into position and seat into the retaining spring. Inspect the shoe assembly position. The shoe must be central on the backing plate with both tips located in the slots.
  3. Adjust the park brake shoe. See PARK BRAKE ADJUSTMENT  under ADJUSTMENTS & INSPECTION. Install the rotor. Install the park brake cable to the park brake actuator lever.
  4. Tighten the nut to the intermediate cable at the equalizer. Tighten the nut specification. See TORQUE SPECIFICATIONS . Install the tire and wheel. Remove the safety stands. Lower the vehicle. Adjust park brake cable. See PARK BRAKE ADJUSTMENT  under REMOVAL & INSTALLATION.
  5. Enable the park brake cable automatic adjuster. See Enabling the Park Brake Cable Automatic Adjuster .
scientia non olet · About LEMON Manuals