LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc Brakes >> Removal & Installation >> Park Brake Pedal Assembly >> Removal

Park Brake Pedal Assembly: Removal

  1. Disconnect the negative battery cable
  2. Disable the park brake cable automatic adjuster. Refer to Disabling the Park Brake Cable Automatic Adjuster .
  3. Remove the left side hinge pillar panel. Remove the MID-Bussed Electrical Center bracket. Disconnect the park brake warning light connection. See Fig 1. Disconnect the park brake release cable from the park brake lever.
  4. Remove the park brake lever mounting nuts. See Fig 2. Disconnect the front park brake cable from the park brake lever. See Fig 3. Remove the park brake lever.
Fig 1: Disconnecting/Connecting Park Brake Warning Light Connector
G00303335Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing/Installing Park Brake Lever Mounting Nuts
G00303336Courtesy of GENERAL MOTORS CORP.
Fig 3: Disconnecting/Connecting Front Park Brake Cable From Park Brake Lever
G00303337Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals