LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc Brakes >> Removal & Installation >> Park Brake Cable >> Installation

Park Brake Cable: Installation

  1. Install the cable. Snap the retainer tabs into the body mount. Connect the front cable to the rear cable. Route the cable in through the floor pan and engage the grommet. Remove the safety stands. Lower the vehicle.
  2. Roll the carpet into place. Install the park brake pedal. See PARK BRAKE PEDAL ASSEMBLY .
  3. Enable the park brake cable automatic adjuster. See Enabling the Park Brake Cable Automatic Adjuster .


  1. Install the left rear cable taking care to correctly route the cable through the cable guide. Install the cable to the lever.
  2. Install the cable to the backing plate by compressing the spring, routing the cable through the slot in the backing plate and pressing the cable into the backing plate until the locking tabs snap into place.
  3. Install the left rear cable to the cable support. Install the left rear cable to the equalizer until the locking tabs snap into place. Connect the left rear cable to the front cable. Remove the safety stands. Lower the vehicle.
  4. Enable the park brake cable automatic adjuster. See Enabling the Park Brake Cable Automatic Adjuster .


  1. Install the right rear cable taking care to correctly route the cable through the cable guide. Install the cable to the lever. Install the cable to the backing plate by compressing the spring, routing the cable through the slot in the backing plate and pressing the cable into the backing plate until the locking tabs snap into place.
  2. Position the right rear cable and the clips on the track bar. Install the track bar clips to the locating tabs on the track bar. Install the right rear cable to the cable support.
  3. Install the right rear cable to the equalizer. Remove the safety stands. Lower the vehicle.
  4. Enable the park brake cable automatic adjuster. See Enabling the Park Brake Cable Automatic Adjuster .