LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Disc Brakes >> Adjustments & Inspection >> Park Brake Shoe Inspection

Park Brake Shoe Inspection

WARNING: Avoid grinding brake linings, sanding brake linings or cleaning wheel brake parts with a dry brush or with compressed air, when servicing wheel brake parts. Some models or aftermarket brake parts may contain asbestos fibers which can become airborne in dust. Breathing dust with asbestos fibers may cause serious bodily harm. Use a water-dampened cloth in order to remove any dust on brake parts. Equipment is available commercially in order to perform this washing function. These wet methods prevent fibers from becoming airborne.
  1. Raise and support the vehicle.
  2. Remove the tire and wheel.
  3. Remove the rear brake caliper bracket with the rear brake caliper. See BRAKE CALIPER BRACKET  under REMOVAL & INSTALLATION.
  4. Remove the rear brake rotor. See BRAKE ROTOR  under REMOVAL & INSTALLATION.
  5. Inspect and replace the park brake shoe and lining if any excessive wear is indicated by the park brake lining being worn down to the shoe, the brake lining is cracking or if there is oil or fluid contamination of the brake lining.
  6. Adjust the park brake shoe. See PARK BRAKE ADJUSTMENT .
  7. Install the rear brake rotor. See BRAKE ROTOR  under REMOVAL & INSTALLATION.
  8. Install the rear brake caliper with the rear brake caliper bracket. See BRAKE CALIPER BRACKET  under REMOVAL & INSTALLATION.
  9. Install the tire and wheel.
  10. Lower the vehicle.
scientia non olet · About LEMON Manuals