LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Steering Column Switches >> Steering Wheel And Column >> Repair Instructions >> Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement >> Removal Procedure

Removal Procedure

    CAUTION: Refer to SIR Caution .
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 .
  2. Remove the SIR coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement (Coil) .
  3. Remove and discard the bearing retainer using J 23653-SIR and J 42137  . See Special Tools .
  4. Remove J 23653-SIR and J 42137  from the steering shaft. See Special Tools .
    Fig 1: Depressing Lock Plate Using J 23653-SIR And J 42137
    GM371185Courtesy of GENERAL MOTORS CORP.
    5. Fig 2: Disassembling Turn Signal Cancel Cam, Steering Shaft Upper Bearing Spring & Components
    GM761443Courtesy of GENERAL MOTORS CORP.
  5. Remove the shaft lock (2) or the cam orientation plate (1).
    6. IMPORTANT: Do not wipe the lubricant off the turn signal cancel cam assembly.
  6. Remove the turn signal cancel cam assembly (3).
  7. Remove the upper bearing spring (4).
  8. Remove the upper bearing inner race seat (5).
  9. Remove the inner race (6).
scientia non olet · About LEMON Manuals