Noise in Steering Column
Noise in Steering Column
| Step | Action | Yes | No |
|---|---|---|---|
| 1 | Did you review the Steering Wheel and Column Description and perform the necessary inspections? | Go to Step 2 | Go to Symptoms - Steering Wheel and Column |
| 2 | Verify that noise is present in the steering column during operation. Is noise present in the steering column during operation? |
Go to Step 3 | System OK |
| 3 | Inspect the steering column components for looseness. Is the steering column components loose? |
Go to Step 10 | Go to Step 4 |
| 4 | Inspect the SIR coil for noise. Is the SIR coil noisy? |
Go to Step 11 | Go to Step 5 |
| 5 | Inspect the horn contact ring for lubrication. Is the horn contact ring lubricated? |
Go to Step 12 | Go to Step 6 |
| 6 | Inspect the lock plate retaining ring for the correct installation. Is the lock plate retaining ring installed properly? |
Go to Step 13 | Go to Step 7 |
| 7 | Inspect the shaft bearing for the following conditions:
Are the bearings in need of repair or replacement? |
Go to Step 14 | Go to Step 8 |
| 8 | Inspect the spherical joint for lubrication. Is the spherical joint lubricated? |
Go to Step 15 | Go to Step 9 |
| 9 | Inspect the steering column coupling for looseness. Is the steering column coupling loose? |
Go to Step 16 | Go to Step 3 |
| 10 | Tighten the steering column components to specifications. Refer to Fastener Tightening Specifications . Did you complete the repair? |
Go to Step 17 | - |
| 11 | Replace the SIR coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement (Coil)
. Did you complete the repair? |
Go to Step 17 | - |
| 12 | Lubricate the horn contact ring. Did you complete the repair? |
Go to Step 17 | - |
| 13 | Install the lock plate retaining ring properly. Did you complete the repair? |
Go to Step 17 | - |
| 14 | Repair the shaft bearings as necessary. Refer to Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement and to Steering Column Shaft Replacement . Did you complete the repair? |
Go to Step 17 | - |
| 15 | Lubricate the spherical joints. Did you complete the repair? |
Go to Step 17 | - |
| 16 | Tighten the steering column coupling to specifications. Refer to Fastener Tightening Specifications . Did you complete the repair? |
Go to Step 17 | - |
| 17 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 3 |