LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting Systems >> Diagnostic Information and Procedures >> Daytime Running Lamps (DRL) Always On

Daytime Running Lamps (DRL) Always On

Daytime Running Lamps (DRL) Always On

Step Action Yes No
Schematic Reference: Headlights/Daytime Running Lights (DRL) Schematics 
Connector End View Reference:  Lighting Systems Connector End Views   or  Body Control System Connector End Views  in Body Control System
1 Did you perform the Lighting Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - Lighting Systems 
2
  1. Ensure the park brake is released.
  2. Turn ON the ignition, with the engine OFF.
  3. With the brake pedal depressed, place the gear selector in any drive gear.
  4. Place the headlamps in the ON position.
Does the system operate normally?		 Go to Testing for Electrical Intermittents in Wiring Systems Go to Step 3 
3
  1. Place the headlamps in the AUTO position.
  2. Disconnect the daytime running lamp (DRL) relay.
Do the DRL turn OFF?		 Go to Step 4  Go to Step 7 
4
  1. Reconnect the DRL relay.
  2. Use the scan tool to observe the DRL parameter and command the DRL ON and OFF several times.
Does the DRL parameter change states as expected?		 Go to Step 5  Go to Step 6 
5 Inspect for poor connections at the harness connector of the DRL relay. Refer to Testing for Intermittent Conditions and Poor Connections andConnector Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 10  Go to Step 8 
6 Inspect for poor connections at the harness connector of the body control module (BCM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 10  Go to Step 9 
7 Repair the DRL supply voltage circuit. Refer to Wiring Repairs in Wiring Systems.
Did you complete the repair?		 Go to Step 10  -
8 Replace the DRL relay. Refer to Relay Replacement (Within an Electrical Center) or Relay Replacement (Attached to Wire Harness) in Wiring Systems.
Did you complete the replacement?		 Go to Step 10  -
9
IMPORTANT: Perform the setup procedure for the BCM.
Replace the BCM. Refer to Body Control Module Replacement in Body Control System.Did you complete the replacement?		 Go to Step 10  -
10 Operate the system in order to verify the repair.
Did you correct the condition?		 System OK Go to Step 3 
scientia non olet · About LEMON Manuals