Installation Procedure

Fig 1: I/P Top Cover

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the upper trim pad to the IP.
Tighten: Tighten the screws to 2 N.m (18 lb in).
Install the right trim panel accessory to the IP.
Tighten: Tighten the screws to 2 N.m(18 lb in).
Install the center trim panel to the IP compartment. Refer to Trim Panel Replacement - Instrument Panel (I/P) Center .
Tighten: Tighten the screws to 2 N.m (18 lb in).
Install the left trim plate to the IP. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory Left .
Tighten: Tighten the screws to 2 N.m (18 lb in).
Install the right trim plate to the IP. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory Right .
Tighten: Tighten the screws to 2 N.m (18 lb in).
Install the knee bolster to the IP compartment. Refer to Trim Panel Replacement - Knee Bolster .
Tighten: Tighten the screws to 2 N.m (18 lb in).
Install the IP compartment door. Refer to Compartment Replacement - Instrument Panel (I/P) .
Tighten: Tighten the screws to 2 N.m (18 lb in).
Install the trim panel to the IP cluster. Refer to Trim Panel Replacement - Instrument Panel (I/P) Cluster .
Tighten: Tighten the screws to 2 N.m (18 lb in).
Install the door striker to the IP compartment. Refer to Striker Replacement - Instrument Panel (I/P) Compartment .
Tighten: Tighten the screws to 2 N.m (18 lb in).
Install the assist handle to the IP. Refer to Instrument Panel (I/P) Assist Handle Replacement .
Tighten all parts of the center console. Refer to Console Replacement .