LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gages, And Console >> Repair Instructions >> Lock Cylinder Replace - Console Compartment Door >> Installation Procedure

Installation Procedure

    Fig 1: Locating Lock Cylinder Retaining Clip
    GM826120Courtesy of GENERAL MOTORS CORP.
  1. Install a new lock cylinder (2) by pressing inwards until it is seated.
  2. Install the retaining clip (1).
  3. Ensure the linkage for the top compartment door are all connected before installing the inside panel.
  4. Install the inside panel.
    5. Fig 2: Console Compartment Center Door Latch
    GM838962Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the 11 screws.

    Tighten:  Tighten the screws to 1.6 N.m (14 lb in).

    6. Fig 3: Compartment Door & Console
    GM838971Courtesy of GENERAL MOTORS CORP.
  6. Inspect the operation of the top compartment door.
  7. Install the compartment door to the console. Refer to Door Replacement - Console Compartment Center .
scientia non olet · About LEMON Manuals