LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gages, And Console >> Repair Instructions >> Instrument Panel Cluster (IPC) Replacement >> Removal Procedure

Removal Procedure

IMPORTANT: The ignition switch must be in the OFF position when removing the instrument panel cluster.
    Fig 1: I/P Cluster Trim Panel Screws
    GM815927Courtesy of GENERAL MOTORS CORP.
  1. Remove the I/P cluster trim plate from the instrument panel. Refer to Trim Panel Replacement - Instrument Panel (I/P) Cluster .
  2. Remove the screws from the I/P cluster to instrument panel.
    3. Fig 2: I/P Cluster
    GM816330Courtesy of GENERAL MOTORS CORP.
  3. Remove the I/P cluster from the instrument panel.
    4. Fig 3: I/P Cluster Electrical Connections
    GM816329Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the I/P cluster electrical connections.
scientia non olet · About LEMON Manuals