LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gages, And Console >> Repair Instructions >> Cigar Lighter Housing Or 12 Volt Accessory Power Receptacle Replacement >> Removal Procedure

Removal Procedure

  1. Remove the power port/lighter socket fuse.
    2. Fig 1: Identifying Cigar Lighter
    GM815935Courtesy of GENERAL MOTORS CORP.
  2. Lift up the front cover of the power socket or remove cigarette lighter.
    3. Fig 2: Inserting J 42059
    GM378525Courtesy of GENERAL MOTORS CORP.
  3. Insert the J 42059  into the socket sleeve. See Special Tools . Tilt the tool so that the tool fits into the slots on the sides of the socket sleeve.
    4. Fig 3: Holding Plastic Ring & Pulling Out Receptacle
    GM378524Courtesy of GENERAL MOTORS CORP.
  4. While holding the plastic ring in place, pull the socket out of the assembly to remove the outlet.
    5. Fig 4: Removing Cigar Housing Using Grinding Tool
    GM1120988Courtesy of GENERAL MOTORS CORP.
  5. If J 42059 tool fails to release the lighter socket from the retainer, perform the following alternate method:
    1. Insert a small grinding tool with a cutoff wheel into the socket.
    2. Remove the plastic latches in the 3 mm (0.11 in) square windows.
    3. Use the J 42059  as directed above to remove the socket. See Special Tools .
  6. Remove the electrical connector from the socket.
scientia non olet · About LEMON Manuals