Wireless Seat Belt Reminder Symptom Troubleshooting - The buckle state is stuck at "unbuckled," regardless of the actual state of the buckle: Inspection

Center Rear Second Seat Belt Buckle Switch Inspection 

Test Procedure 

• Preparation
  • Center rear second seat belt buckle switch connector (4P): disconnected
• Procedure
  • Perform the inspection according to the following table.

    Refer to the Open/Shorted Wire Inspection Description for the method to inspect the shorted circuit below, then start to inspect according to circumstances.

			(Disconnected) Center rear second seat belt buckle switch connector (4P) female terminals
		IG Mode	Courtesy of HONDA, U.S.A., INC.	Normal Conditions
	Center Rear Second Seat Belt Buckle Switch Inspection	OFF*1		There is more than 1 MOhms
	Center Rear Second Seat Belt Buckle Switch Inspection	OFF*2		There is less than 1?

*1: Unbuckle the center rear second seat belt buckle.

*2: Buckle the center rear second seat belt buckle.

Results 

• If abnormal, there is a problem in the circuit.