DTC B1228 (D and AUTO)

DTC B1228 or DTC indicator D and AUTO  : A Short in the Outside Air Temperature Sensor Circuit

DTC (AC)

1. Problem verification

   - 1. Clear the DTC with the HDS.

   - 2. Turn the vehicle to the OFF (LOCK) mode then the ON mode.

   - 3. Do the Self-Diagnostic Function with the HDS or the climate control unit.

   - 4. Check for DTCs.

   DTC Description	DTC
   B1228 A short in the outside air temperature sensor circuit

   Is DTC B1228 or D and AUTO indicated?

   YES 

   Go to step 2.

   NO 

   Intermittent failure. Check for loose wires or poor connections on the outside air temperature circuit.

2. Shorted wire check (TAM line)

   - 1. Turn the vehicle to the OFF (LOCK) mode.

   - 2. Disconnect the following connectors.

   Climate control unit connector C (12P)

   Outside air temperature sensor 2P connector

   - 3. Check for continuity between test points 1 and 2.

   Test condition	Vehicle OFF (LOCK) mode
   	Climate control unit connector C (12P): disconnected
   	Outside air temperature sensor 2P connector: disconnected
   Test point 1	Climate control unit connector C (12P) No. 9 - Refer to: Climate Control Unit Connector For Inputs and Outputs (2019 2020 2021), or Climate Control Unit Connector For Inputs and Outputs (2016 2017 2018)
   Test point 2	Body ground

   Is there continuity?

   YES 

   Repair a short to body ground in the wire between the climate control unit and the outside air temperature sensor.

   NO 

   The TAM wire is not shorted. Go to step 3.

3. Shorted wire check (TAM line to SENSOR(COM) line)

   - 1. Disconnect the following connector.

   Climate control unit connector A (32P)

   - 2. Check for continuity between test points 1 and 2.

   Test condition	Vehicle OFF (LOCK) mode
   	Climate control unit connector A (32P): disconnected
   	Climate control unit connector C (12P): disconnected
   	Outside air temperature sensor 2P connector: disconnected
   Test point 1	Climate control unit connector A (32P) No. 18 - Refer to: Climate Control Unit Connector For Inputs and Outputs (2019 2020 2021), or Climate Control Unit Connector For Inputs and Outputs (2016 2017 2018)
   Test point 2	Climate control unit connector C (12P) No. 9 - Refer to: Climate Control Unit Connector For Inputs and Outputs (2019 2020 2021), or Climate Control Unit Connector For Inputs and Outputs (2016 2017 2018)

   Is there continuity?

   YES 

   Repair a short in the wires between the climate control unit and the outside air temperature sensor.

   NO 

   The TAM wire to SENSOR(COM) wire are OK. Go to step 4.

4. Outside air temperature sensor check

   - 1. Test the outside air temperature sensor.

   Is the outside air temperature sensor OK?

   YES 

   Replace the climate control unit .

   NO 

   Replace the outside air temperature sensor .