DTC : B1FB3

DTC B1FB3  : Left rear heater not heating (second row seat)

DTC (Second Row Seat Heater Control Unit)

NOTE: 

• If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A - Go to: Body Electrical Troubleshooting - B-CAN System Diagnosis Test Mode A - Initial Communication and DTC Checks .
• The seat heater control unit does not turn on the seat heater until the seat core temperature is 85 degrees or less. Make sure the seat core temperature is below 85 degrees before troubleshooting.

1. Problem verification

   -1. Clear the DTCs with the HDS.

   Clear DTCs

   - 2. Turn the vehicle to the OFF (LOCK) mode and then the ON mode.

   - 3. Check for DTCs with the HDS.

   DTC Description	DTC
   B1FB3 Left rear heater not heating (second row seat)

   Is DTC B1FB3 indicated?

   YES 

   Go to step 2.

   NO 

   Intermittent failure, the system is OK at this time. Check for loose or poor connections.

2. DTC check

   -1. Check for DTCs with the HDS.

   DTC Description	DTC
   B1FA0 Left rear heater thermistor circuit open (second row seat)
   B1FA1 Left rear heater thermistor circuit short (second row seat)
   B1FAB Left rear heater current abnormal high (second row seat)
   B1FAC Left rear heater current abnormal low (second row seat)

   Are DTCs B1FA0, B1FA1, B1FAB, and/or B1FAC indicated?

   YES 

   Go to DTC B1FA0  troubleshooting.

   YES 

   Go to DTC B1FA1  troubleshooting.

   YES 

   Go to DTC B1FAB  troubleshooting.

   YES 

   Go to DTC B1FAC  troubleshooting.

   NO 

   Replace the left Second Row Seat Cushion Heater .