DTC : B1376 (2019 2020 2021)
DTC B1376 : Tailgate Outer Handle Switch Circuit Malfunction
- NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A - Initial Communication and DTC Checks .
- If the motor does not operate, do the Power Tailgate Motor Test first.
| DTC Description | DTC |
|---|---|
| B1376 Tailgate Outer Handle Switch Circuit Malfunction |
DTCs (Power Tailgate Control Unit)
- Problem verification
- 1. Clear the DTCs with the HDS.
Clear DTCs
- 2. Press the tailgate outer handle switch button for more than 1 second.
- 3. Check for DTCs with the HDS.
DTC Description DTC B1376 Tailgate Outer Handle Switch Circuit Malfunction Is DTC B1376 indicated?
YES
Go to step 2.
NO
Intermittent failure, the system is OK at this time. Check for loose or poor connections.
- Shorted wire check (PTG O/H SW line)
- 1. Turn the vehicle to the OFF (LOCK) mode.
- 2. Disconnect the following connector.
Power tailgate control unit connector A (24P) Keyless access/TPMS control unit connector C (20P) - 3. Check for continuity between test points 1 and 2.
Test condition Vehicle OFF (LOCK) mode
Power tailgate control unit connector A (24P): disconnected
Keyless access/TPMS control unit connector C (20P): disconnectedTest point 1 Power tailgate control unit connector A (24P) No. 23 - Refer to:
Power Tailgate Control Unit Connector for Inputs and Outputs (2019 2020 2021)Test point 2 Body ground Is there continuity?
YES
Repair a short to ground in the PTG O/H SW wire.
NO
Repair a short to ground in the PTG SCOM wire.