DTC : B2610
DTC B2610 : Front 1st Sensor Failure
NOTE:
- If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A - Go to: Body Electrical Troubleshooting - B-CAN System Diagnosis Test Mode A - Initial Communication and DTC Checks .
- The count of the number of the sensor starts from the sensor near to the control unit.
| DTC Description | DTC |
|---|---|
| B2610 Front 1st sensor failure |
DTC (Parking and Back-Up Sensor Control Unit)
- Problem verification
- 1. Clear the DTCs with the HDS.
Clear DTCs
- 2. Turn the vehicle to the OFF (LOCK) mode and then the ON mode.
- 3. Wait for at least 6 seconds.
- 4. Check for DTCs with the HDS.
DTC Description DTC B2610 Front 1st sensor failure Is DTC B2610 indicated?
YES
Replace the left Front Corner Sensor .
NO
Intermittent failure, the system is OK at this time. Check for loose or poor connections.