Removal and Installation

NOTE:  Keep grease away from the brake disc/drum and the brake pads.

1. Vehicle - Lift
2. Rear Wheel - Remove
3. Parking Brake - Release
4. Brake Caliper - Remove
   Fig 1: Rear Brake Caliper With Torque Specifications

   Courtesy of HONDA, U.S.A., INC.

   NOTE: 

   • To prevent damage to the caliper assembly or brake hose, use a short piece of wire to hang the caliper assembly from the undercarriage.
   • Do not twist the brake hose excessively.
5. Brake Disc/Drum - Remove

   Courtesy of HONDA, U.S.A., INC.

   1. Remove the brake disc/drum (A). Remove the access plug (B), then if necessary, turn the adjuster nut (C) with a flat-tip screwdriver until the shoes become loose. If the brake disc/drum is stuck to the hub bearing unit, thread two 8 x 1.25 mm bolts (D) into the brake disc/drum to push it away from the hub bearing unit. Turn each bolt 90 degrees at a time to prevent the brake disc/drum from binding.

6. All Removed Parts - Install

   1. Install the brake disc/drum in the reverse order of removal, and note these items: Before installing the brake disc/drum, clean the mating surfaces between the hub bearing unit and the inside of the brake disc/drum. Adjust the parking brake .

7. Rear Brake Disc/Drum Runout - Inspect