Rear Brake Caliper Removal And Installation: Removal

Do not spill brake fluid on the vehicle; it may damage the paint. If brake fluid does contact the paint, wash it off immediately with water.

Brake Caliper Body - Remove

Fig 1: Rear Brake Caliper Replacement Components

Courtesy of HONDA, U.S.A., INC.

NOTE: After removal, plug the ends of the hoses and the joints to prevent spilling brake fluid.

1. Remove the banjo bolt (A), and disconnect the brake hose (B) from the caliper body (C).

2. Remove the caliper body.

Caliper Pin and Pin Boot - Remove

Fig 2: Rear Caliper Pin and Pin Boot Replacement Components

Courtesy of HONDA, U.S.A., INC.

1. Remove the caliper pins (A).

NOTE: The upper and lower caliper pins are different. During installation, make sure the caliper pins are in the proper positions.

2. Remove the bush (B) from the upper caliper pin.

3. Remove the pin boots (C).