NO SOUND/NO DISPLAY WITH AUXILIARY VIDEO ACCESSORY INPUTS (With Navigation) (2016 2017 2018)
NOTE:
- Check the vehicle 12 volt battery condition first - Refer to:
- Check that the auxiliary device is properly connected, and has fresh batteries or power source connected.
- Do not connect an RCA type shorting plug with the RES auxiliary jack assembly, or system damage may occur.
- You need to switch on the REAR POWER button for the rear display, remote controls, and sound to operate.
12 Volt Battery Test (Without Auto Idle Stop System) or
12 Volt Battery Test (With Auto Idle Stop System) .
- Problem verification
-1. Turn the vehicle to the ON mode.
- 2. Turn on the rear entertainment system.
- 3. Connect an auxiliary video accessory to the RES auxiliary jack assembly, and check the sound and image on the rear display.
Does the image on the rear display appear and is the sound normal?
YES
Intermittent failure, the system is OK at this time.
NO
The failure is duplicated, go to step 2.
- Determine possible failure area (auxiliary video accessory, audio signal circuit side, video signal circuit side)
-1. Substitute a known-good auxiliary video accessory and/or RCA cable, and recheck.
Does the image on the rear display appear and is the sound normal?
YES
Original auxiliary video accessory or RCA cable is faulty.
NO: No sound
Go to step 7.
NO: No display
Go to step 3.
- Shorted wire check (AUX1 NTSC SIG, AUX1 NTSC GND lines)
-1. Turn the vehicle to the OFF (LOCK) mode.
- 2. Disconnect the following connectors.
Rear controller and screen connector B (12P) RES auxiliary jack assembly 14P connector - 3. Check for continuity between test points 1 and 2.
Test condition Vehicle OFF (LOCK) mode Rear controller and screen connector B (12P) disconnected RES auxiliary jack assembly 14P connector: disconnected Test circuit 1 Test point 1 Rear controller and screen connector B (12P) No. 3 Test point 2 Body ground Test circuit 2 Test point 1 Rear controller and screen connector B (12P) No. 8 Test point 2 Body ground Is there continuity?
YES
There is a short to body ground in the wire(s) between the rear controller and screen and the RES auxiliary jack assembly. Replace the affected shielded harness.
NO
The AUX1 NTSC SIG and AUX1 NTSC GND wires are not shorted. Go to step 4.
- Shorted wire check (AUX1 NTSC lines)
-1. Check for continuity between test points 1 and 2.
Test condition Vehicle OFF (LOCK) mode Rear controller and screen connector B (12P) disconnected RES auxiliary jack assembly 14P connector: disconnected Test point 1 Test points 2 No. 3 No. 8, No. 9 No. 8 No. 9 Is there continuity between any of the terminals?
YES
There is a short in the wires between the rear controller and screen and the RES auxiliary jack assembly. Replace the affected shielded harness.
NO
The AUX1 NTSC wires are not shorted. Go to step 5.
- Open wire check (AUX1 NTSC SIG, AUX1 NTSC GND lines)
-1. Check for continuity between test points 1 and 2.
Test condition Vehicle OFF (LOCK) mode Rear controller and screen connector B (12P) disconnected RES auxiliary jack assembly 14P connector: disconnected Test circuit 1 Test point 1 Rear controller and screen connector B (12P) No. 3 Test point 1 RES auxiliary jack assembly 14P connector No. 14 - Refer to:
RES Auxiliary Jack Assembly Connector for Inputs and Outputs (2016 2017 2018) .Test circuit 2 Test point 1 Rear controller and screen connector B (12P) No. 8 Test point 2 RES auxiliary jack assembly 14P connector No. 13 - Refer to:
RES Auxiliary Jack Assembly Connector for Inputs and Outputs (2016 2017 2018) .Is there continuity
YES
The AUX1 NTSC SIG and AUX1 NTSC GND wires are OK. Go to step 6.
NO
There is an open in the wire(s) between the rear controller and screen and the RES auxiliary jack assembly. Replace the affected shielded harness.
- RES auxiliary jack assembly check (substitution)
-1. Substitute a known-good RES auxiliary jack assembly, and recheck.
Rear Entertainment System (RES) Auxiliary Jack Assembly Removal And Installation
Does the symptom go away?
YES
Replace the original RES auxiliary jack assembly.
NO
Replace the rear controller and screen. Rear Controller and Screen Removal and Installation (2016 2017 2018) .
- Shorted wire check (AUX1 L, AUX1 R lines)
-1. Turn the vehicle to the OFF (LOCK) mode.
- 2. Disconnect the following connectors.
Rear controller and screen connector B (12P) RES auxiliary jack assembly 14P connector - 3. Check for continuity between test points 1 and 2.
Test condition Vehicle OFF (LOCK) mode Rear controller and screen connector B (12P) disconnected RES auxiliary jack assembly 14P connector: disconnected Test circuit 1 Test point 1 Rear controller and screen connector B (12P) No. 5 Test point 2 Body ground Test circuit 2 Test point 1 Rear controller and screen connector B (12P) No. 11 Test point 2 Body ground Is there continuity?
YES
There is a short to body ground in the wire(s) between the rear controller and screen and the RES auxiliary jack assembly. Replace the affected shielded harness.
NO
The AUX1 L and AUX1 R wires are not shorted. Go to step 8.
- Shorted wire check (AUX1 lines)
-1. Check for continuity between test points 1 and 2.
Test condition Vehicle OFF (LOCK) mode Rear controller and screen connector B (12P) disconnected RES auxiliary jack assembly 14P connector: disconnected Test point 1 Test points 2 No. 5 No. 6, No. 11, No. 12 No. 11 No. 6, No. 12 Is there continuity between any of the terminals?
YES
There is a short in the wires between the rear controller and screen and the RES auxiliary jack assembly. Replace the affected shielded harness.
NO
The AUX1 wires are not shorted. Go to step 9.
- Open wire check (AUX1 L, AUX1 R, AUX1 L/R GND lines)
-1. Check for continuity between test points 1 and 2.
Test condition Vehicle OFF (LOCK) mode Rear controller and screen connector B (12P) disconnected RES auxiliary jack assembly 14P connector: disconnected Test point 1: Test point 2: RES auxiliary jack assembly 14P connector - Refer to:
RES Auxiliary Jack Assembly Connector for Inputs and Outputs (2016 2017 2018) .No. 5 No. 11 No. 6 No. 10 No. 11 No. 9 Is there continuity
YES
The AUX1 L, AUX1 R, and AUX1 L/R GND wires are OK. Go to step 10.
NO
There is an open in the wire(s) between the rear controller and screen and the RES auxiliary jack assembly. Replace the affected shielded harness.
- Shorted wire check (RES AUDIO L SIG, RES AUDIO R SIG lines)
-1. Disconnect the following connectors.
Rear controller and screen connector A (24P) Audio-navigation unit connector H (24P) - 2. Check for continuity between test points 1 and 2.
Test condition Vehicle OFF (LOCK) mode Audio-navigation unit connector H (24P) disconnected Rear controller and screen connector A (24P) disconnected Test circuit 1 Test point 1 Audio-navigation unit connector H (24P) No. 20 -
Refer to:
Audio-Navigation Unit Connector for Inputs and Outputs (2016)
Audio-Navigation Unit Connector for Inputs and Outputs (2017 2018)Test point 2 Body ground Test circuit 2 Test point 1 Audio-navigation unit connector H (24P) No. 21 -
Refer to:
Audio-Navigation Unit Connector for Inputs and Outputs (2016) or
Audio-Navigation Unit Connector for Inputs and Outputs (2017 2018)Test point 2 Body ground Is there continuity?
YES
There is a short to body ground in the wire(s) between the audio-navigation unit and the rear controller and screen. Replace the affected shielded harness.
NO
The RES AUDIO L SIG and RES AUDIO R SIG wires are not shorted. Go to step 11.
- Shorted wire check (RES AUDIO lines)
-1. Check for continuity between test points 1 and 2.
Test condition Vehicle OFF (LOCK) mode Audio-navigation unit connector H (24P) disconnected Rear controller and screen connector A (24P) disconnected Test points 1 Audio-navigation unit connector H (24P) - Refer to:
Audio-Navigation Unit Connector for Inputs and Outputs (2016) or
Audio-Navigation Unit Connector for Inputs and Outputs (2017 2018)
Test points 2 Audio-navigation unit connector H (24P) - Refer to:
Audio-Navigation Unit Connector for Inputs and Outputs (2016) or
Audio-Navigation Unit Connector for Inputs and Outputs (2017 2018)
No. 20 No. 8, No. 9, No. 21 No. 21 No. 8, No. 9 Is there continuity between any of the terminals?
YES
There is a short in the wires between the audio-navigation unit and the rear controller and screen. Replace the affected shielded harness.
NO
The RES AUDIO wires are not shorted. Go to step 12.
- Open wire check (RES AUDIO L SIG, RES AUDIO R SIG, RES AUDIO L/R GND lines)
-1. Check for continuity between test points 1 and 2.
Test condition Vehicle OFF (LOCK) mode Audio-navigation unit connector H (24P) disconnected Rear controller and screen connector A (24P) disconnected Test point 1: Audio-navigation unit connector H (24P) - Refer to:
Audio-Navigation Unit Connector for Inputs and Outputs (2016) or
Audio-Navigation Unit Connector for Inputs and Outputs (2017 2018)
Test point 2: No. 8 No. 5 No. 20 No. 16 No. 21 No. 4 Is there continuity
YES
The RES AUDIO L SIG, RES AUDIO R SIG and RES AUDIO L/R GND wires are OK. Go to step 13.
NO
There is an open in the wire(s) between the audio-navigation unit and the rear controller and screen. Replace the affected shielded harness.
- RES auxiliary jack assembly check (substitution)
-1. Substitute a known-good RES auxiliary jack assembly, and recheck.
Rear Entertainment System (RES) Auxiliary Jack Assembly Removal And Installation
Does the symptom go away?
YES
Replace the original RES auxiliary jack assembly.
Rear Entertainment System (RES) Auxiliary Jack Assembly Removal And Installation
NO
Replace the rear controller and screen Rear Controller and Screen Removal and Installation (2016 2017 2018) , and recheck.
If the symptom does not go away, Audio-Navigation Unit Removal and Installation (2016 2017 2018) .