Left/Right Channel ID

Do this test to confirm proper channel routing.

1. Insert the Diagnostic CD (07AAZ-SDBA100) into the BD player unit or the CD player unit.

2. Play track No. 1 (left, both, right channel ID) at a normal, or slightly higher than normal, volume level.

3. The voice should be audible only from the channel or channels when indicated.

• If the channel ID is correct for each side, go to Phase Test.
• If the channel ID is not correct, check for:
• • Shorted speaker wire
  • Open in speaker wire
  • Shorted speaker
  • Loose connection or poor pin fit
  • Faulty stereo amplifier or tuner-amplifier unit
  • Faulty BD player unit or CD player unit