DTC: C0010-49, C0011-49, C0014-49, C0015-49, C0018-49, C0019-49, C001C-49, C001D-49

DTC C0010-49  : Inlet Solenoid (Left Front) Circuit Failure

DTC C0011-49  : Outlet Solenoid (Left Front) Circuit Failure

DTC C0014-49  : Inlet Solenoid (Right Front) Circuit Failure

DTC C0015-49  : Outlet Solenoid (Right Front) Circuit Failure

DTC C0018-49  : Inlet Solenoid (Left Rear) Circuit Failure

DTC C0019-49  : Outlet Solenoid (Left Rear) Circuit Failure

DTC C001C-49  : Inlet Solenoid (Right Rear) Circuit Failure

DTC C001D-49  : Outlet Solenoid (Right Rear) Circuit Failure

NOTE: Before You Troubleshoot, Review The General Troubleshooting Information .

DTCs (VSA)

1. Problem verification

   -1. Turn the vehicle to the ON mode.

   - 2. Clear the DTC with the HDS.

   - 3. Turn the vehicle to the OFF (LOCK) mode, then start the engine.

   - 4. Check for DTCs with the HDS.

   DTC Description	DTC	Freeze Frame
   C0010-49 Inlet Solenoid (Left Front) Circuit Failure
   C0011-49 Outlet Solenoid (Left Front) Circuit Failure
   C0014-49 Inlet Solenoid (Right Front) Circuit Failure
   C0015-49 Outlet Solenoid (Right Front) Circuit Failure
   C0018-49 Inlet Solenoid (Left Rear) Circuit Failure
   C0019-49 Outlet Solenoid (Left Rear) Circuit Failure
   C001C-49 Inlet Solenoid (Right Rear) Circuit Failure
   C001D-49 Outlet Solenoid (Right Rear) Circuit Failure

   Is DTC C0010-49, C0011-49, C0014-49, C0015-49, C0018-49, C0019-49, C001C-49, or C001D-49 indicated?

   YES 

   Check for loose terminals and poor connections in the VSA modulator-control unit 38P connector. If they are OK, replace the VSA Modulator-Control Unit. Refer to: replace the VSA modulator-control unit .

   NO 

   Intermittent failure, the system is OK at this time. Refer To Intermittent Failures Troubleshooting . If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the Freeze data/on-board snapshot.