DTC U3000-51 (Gauge control module)
DTC U3000-51 : Reprogramming error
| DTC Description | DTC |
|---|---|
| U3000-51 Reprogramming error |
DTC (Gauge Control Module)
NOTE:
- If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A - Refer to: Body Electrical Troubleshooting - B-CAN System Diagnosis Test Mode A - Initial Communication and DTC Checks .
- Before reprogramming the gauge control module, make sure the 12 volt battery in the vehicle is fully charged, and connect a 12 volt jumper battery (not a battery charger) to maintain system voltage.
- Never turn the vehicle to the ACCESSORY mode or OFF (LOCK) mode, during the reprogramming. If there is a problem with the reprogramming, turn the vehicle to the ON mode.
- Problem verification
-1. Clear the DTCs with the HDS.
-2. Turn the vehicle to the OFF (LOCK) mode and then the ON mode.
-3. Check for DTCs with the HDS.
DTC Description DTC U3000-51 Reprogramming error Is DTC U3000-51 indicated?
YES
Reprogramming the gauge control module.
NO
Intermittent failure, the system is OK at this time.