DTC C0061-F0
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2020 Acura RLX, 2019 Acura RLX, 2018 Acura RLX, 2017 Acura RLX, and 2016 Acura RLX. However, it is still accessible from the selected car via links, so may be relevant.
DTC C0061-F0 : Lateral Acceleration Sensor (Subfault) Fault Detection By Source Module
NOTE:
- Before you troubleshoot, review the general troubleshooting information .
- These DTCs are recorded when the multipurpose camera unit receives the VSA modulator-control unit failure information via the F-CAN.
- If a DTC is recorded again after it is cleared with the HDS, refer to the DTC troubleshoot for the VSA system .
- The functions of the integrated driver support system that will be temporarily canceled when this DTC is recorded can be confirmed with the DTC troubleshooting index .
| DTC Description | DTC | Freeze Frame |
|---|---|---|
| C0061-F0 Lateral Acceleration Sensor (Subfault) Fault Detection By Source Module |
DTC (IDAS)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Turn the vehicle to the OFF (LOCK) mode.
-4. Turn the vehicle to the ON mode, then wait for at least 6 seconds.
-5. Check for DTCs with the HDS.
DTC Description DTC Freeze Frame C0061-F0 Lateral Acceleration Sensor (Subfault) Fault Detection By Source Module Is DTC C0061-F0 indicated?
YES
The failure is duplicated. Go to the indicated DTC's troubleshooting in the VSA system .
NO
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting . If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.