DTC C0010-49, C0011-49, C0014-49, C0015-49, C0018-49, C0019-49, C001C-49, C001D-49

NOTE: Before you troubleshoot, review the general troubleshooting information .

DTC (VSA)

1. Problem verification

   -1. Turn the vehicle to the ON mode.

   -2. Clear the DTC with the HDS.

   -3. Turn the vehicle to the OFF (LOCK) mode, then to the READY TO DRIVE mode.

   -4. Wait for 2 seconds or more.

   -5. Check for DTCs with the HDS.

   DTC Description	DTC
   C0010-49 Inlet Solenoid (Left Front) Circuit Failure
   C0011-49 Outlet Solenoid (Left Front) Circuit Failure
   C0014-49 Inlet Solenoid (Right Front) Circuit Failure
   C0015-49 Outlet Solenoid (Right Front) Circuit Failure
   C0018-49 Inlet Solenoid (Left Rear) Circuit Failure
   C0019-49 Outlet Solenoid (Left Rear) Circuit Failure
   C001C-49 Inlet Solenoid (Right Rear) Circuit Failure
   C001D-49 Outlet Solenoid (Right Rear) Circuit Failure

   Is DTC C0010-49, C0011-49, C0014-49, C0015-49, C0018-49, C0019-49, C001C-49, or C001D-49 indicated?

   YES 

   Check for loose terminals and poor connections in the VSA modulator-control unit 46P connector. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting. If they are OK, replace the VSA modulator-control unit .

   NO 

   Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting .