How to Clear DTCs
WARNING: This page is about a different variant/trim than selected.
1. Turn the vehicle to the OFF (LOCK) mode, then connect the Honda Diagnostic System (HDS) to the DLC
located under the driver's side of the dashboard.
2. Turn the vehicle to the ON mode.
3. Make sure the HDS communicates with the vehicle and the AWD control unit. If it does not communicate, go to the AWD system symptom troubleshooting for HDS does not communicate
4. Clear the DTC(s) by following the screen prompts on the HDS in the AWD WITH INTELLIGENT CONTROL DATA LIST.
5. Turn the vehicle to the OFF (LOCK) mode.
NOTE: If the DTC that was cleared is related to another system, that system's DTC must be repaired, or the AWD DTC will return.