DTC P2715 (CVT)

DTC P2715  : Pressure Control Solenoid "D" Stuck On

NOTE:  Before you troubleshoot, review the General Troubleshooting Information .

DTC (CVT)

1. Problem verification

   -1. Turn the vehicle to the ON mode.

   -2. Clear the DTC with the HDS.

   -3. Start the engine. With the brake pedal pressed, Shift the transmission to N position/mode, then shift to D position/mode. Release the brake pedal, and test-drive the vehicle in D position/mode at speeds 12 mph (20 km/h) or below for at least 10 seconds.

   -4. Turn the engine off. Repeat the test-drive in step 1-3 again.

   -5. Check for Pending or Confirmed DTCs with the HDS.

   DTC Description	Confirmed DTC	Pending DTC	Freeze Frame
   P2715 Pressure Control Solenoid "D" Stuck On

   Is DTC P2715 indicated?

   YES 

   The failure is duplicated. Faulty CVT lock-up clutch control solenoid valve. Replace the valve body assembly .

   NO 

   Intermittent failure, the system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.