DTC P0796 (CVT)

DTC P0796  : Pressure Control Solenoid Valve "C" Performance or Stuck OFF

NOTE:  Before you troubleshoot, review the General Troubleshooting Information .

DTC (CVT)

1. Problem verification

   -1. Turn the vehicle to the ON mode.

   -2. Clear the DTC with the HDS.

   -3. Start the engine in P position/mode. Shift the transmission to N position/mode, then to D position/mode while pressing the brake pedal, and wait for at least 30 seconds.

   -4. Turn the engine off. Repeat the shift lever operational mode in step 1-3 again.

   -5. Check for Pending or Confirmed DTCs with the HDS.

   DTC Description	Confirmed DTC	Pending DTC	Freeze Frame
   P0796 Pressure Control Solenoid Valve "C" Performance or Stuck OFF

   Is DTC P0796 indicated?

   YES 

   The failure is duplicated. Faulty CVT clutch pressure control solenoid valve. Replace the valve body assembly .

   NO 

   Intermittent failure, the system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.