DTC P0341 (2017 2018 2019 2020 2021)

DTC P0341  : CMP Sensor and CKP Sensor Incorrect Phase Detected

NOTE:  Before you troubleshoot, review the general troubleshooting information .

DTC (PGM-FI)

1. Camshaft timing check

   -1. Check the camshaft timing .

   Is the camshaft timing OK?

   YES 

   Go to step 2.

   NO 

   Reset the camshaft timing.

2. Cam chain check

   -1. Check for damage or stretch at the cam chain. .

   Is the cam chain damaged or stretched?

   YES 

   Replace the cam chain and the cam chain auto-tensioner .

   NO 

   Go to step 3.

3. PGM-FI system check (DTC check)

   -1. Press the engine start/stop button to select the ON mode.

   -2. Reset the PCM with the HDS .

   Reset PCM

   -3. Do the CKP pattern clear procedure .

   CRANK PATTERN CLEAR

   -4. Do the PCM idle learn procedure .

   -5. Do the CKP pattern learn procedure .

   CRANK PATTERN LEARNING

   -6. Start the engine, and let it idle.

   -7. Check for Pending or Confirmed DTCs with the HDS.

   DTC Description	Confirmed DTC	Pending DTC
   P0341 CMP Sensor and CKP Sensor Incorrect Phase Detected

   Is DTC P0341 indicated?

   YES 

   Check for poor connections or loose terminals at the CMP sensor, CKP sensor, and the PCM, then go to step 1.

   NO 

   Intermittent failure, the system is OK at this time. If the on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the on-board snapshot .