DTC 66-11, 66-13
DTC 66-11 : Pressure Sensor Circuit Malfunction
DTC 66-13 : Pressure Sensor Malfunction
NOTE: Before you troubleshoot, review the general troubleshooting information .
| DTC Description | DTC | Freeze Frame |
|---|---|---|
| 66-11 Pressure Sensor Circuit Malfunction | ||
| 66-13 Pressure Sensor Malfunction |
DTCs (VSA)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Turn the vehicle to the OFF (LOCK) mode, then to the ON mode.
-4. Check for DTCs with the HDS.
DTC Description DTC Freeze Frame 66-11 Pressure Sensor Circuit Malfunction 66-13 Pressure Sensor Malfunction Is DTC 66-11 or 66-13 indicated?
YES
The failure is duplicated. Go to step 2.
NO
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting .
- VSA modulator-control unit check (update)
-1. Turn the vehicle to the OFF (LOCK) mode.
-2. Update the VSA modulator-control unit if it does not have the latest software .
-3. Turn the vehicle to the OFF (LOCK) mode, then to the ON mode.
-4. Check for DTCs with the HDS.
DTC Description DTC Freeze Frame Is DTC 66-11 or 66-13 indicated?
YES
Check for loose terminals in the VSA modulator-control unit 21P connector. If the VSA modulator-control unit was updated and the symptom/indication is still present, replace the VSA modulator-control unit .
NO
Troubleshooting is complete. If any other DTCs are indicated, go to the indicated DTCs troubleshooting.