DTC 51-11
DTC 51-11 : Motor Malfunction
NOTE: Before you troubleshoot, review the general troubleshooting information .
| DTC Description | DTC | Freeze Frame |
|---|---|---|
| 51-11 Motor Malfunction |
DTCs (VSA)
- Solenoid operation check
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Turn the vehicle to the OFF (LOCK) mode, then to the ON mode.
-4. Wait for 5 seconds.
-5. Operate any one of the four solenoids in the VSA FUNCTION TEST five times with the HDS.
Left Front VSA
Right Front VSA
Left Rear VSA
Right Rear VSA
Check for DTCs with the HDS.
DTC Description DTC Freeze Frame 51-11 Motor Malfunction Is DTC 51-11 indicated?
YES
Go to step 2.
NO
- VSA modulator-control unit check (update)
-1. Update the VSA modulator-control unit if it does not have the latest software .
-2. Turn the vehicle to the OFF (LOCK) mode, then to the ON mode.
-3. Wait for 5 seconds.
-4. Operate any one of the four solenoids in the VSA FUNCTION TEST five times with the HDS.
Left Front VSA
Right Front VSA
Left Rear VSA
Right Rear VSA
Check for DTCs with the HDS.
DTC Description DTC Freeze Frame Is DTC 51-11 indicated?
YES
Check for loose terminals in the VSA modulator-control unit 21P connector. If the VSA modulator-control unit was updated and the symptom/indication is still present, replace the VSA modulator-control unit .
NO
Troubleshooting is complete. If any other DTCs are indicated, go to the indicated DTCs troubleshooting.