LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2021 >> HR-V EX-L, FWD >> Repair and Diagnosis >> Brakes >> Traction Control >> VSA System - DTC Diagnostics >> DTC Troubleshooting >> DTC 12-120, 14-120, 16-120, 18-120

DTC 12-120, 14-120, 16-120, 18-120

DTC 12-120  : Right-Front Wheel Speed Sensor Circuit Malfunction

DTC 14-120  : Left-Front Wheel Speed Sensor Circuit Malfunction

DTC 16-120  : Right-Rear Wheel Speed Sensor Circuit Malfunction

DTC 18-120  : Left-Rear Wheel Speed Sensor Circuit Malfunction

NOTE: Before you troubleshoot, review the general troubleshooting information .

DTC Description DTC Freeze Frame
12-120 Right-Front Wheel Speed Sensor Circuit Malfunction    
14-120 Left-Front Wheel Speed Sensor Circuit Malfunction    
16-120 Right-Rear Wheel Speed Sensor Circuit Malfunction    
18-120 Left-Rear Wheel Speed Sensor Circuit Malfunction    

DTCs (VSA)

  1. Problem verification

    -1. Turn the vehicle to the ON mode.

    -2. Clear the DTC with the HDS.

    -3. Turn the vehicle to the OFF (LOCK) mode.

    -4. Test-drive the vehicle.

    NOTE:  Drive the vehicle on the road, not on a lift.

    -5. Check for DTCs with the HDS.

    DTC Description DTC Freeze Frame
    12-120 Right-Front Wheel Speed Sensor Circuit Malfunction    
    14-120 Left-Front Wheel Speed Sensor Circuit Malfunction    
    16-120 Right-Rear Wheel Speed Sensor Circuit Malfunction    
    18-120 Left-Rear Wheel Speed Sensor Circuit Malfunction    

    Is DTC 12-120, 14-120, 16-120, or 18-120 indicated?

    YES 

    The failure is duplicated. Go to step 2.

    NO 

    Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting .

  2. Shorted wire check (Wheel speed sensor lines to power)

    -1. Turn the vehicle to the OFF (LOCK) mode.

    -2. Disconnect the following connector.

    VSA modulator-control unit 21P connector

    -3. Turn the vehicle to the ON mode.

    -4. Measure the voltage between body ground and the appropriate wheel speed sensor +B terminals of the VSA modulator-control unit 21P connector individually (see table).

    Test condition Vehicle ON mode
      VSA modulator-control unit 21P connector: disconnected
    DTC VSA Modulator-Control Unit 21P Connector Terminal Appropriate Wheel Speed Sensor 2P or 4P Connector Terminal
    12-120 No. 14 Right-front
    14-120 No. 12 Left-front
    16-120 No. 11 Right-rear
    18-120 No. 13 Left-rear

    Is there 0.1 V or more?

    YES 

    Repair a short to power in the wires between the appropriate wheel speed sensor and the VSA modulator-control unit.

    NO 

    The wheel speed sensor wires are not shorted to power. Go to step 3.

  3. Wheel speed sensor check

    -1. Turn the vehicle to the OFF (LOCK) mode.

    -2. Reconnect the following connector.

    VSA modulator-control unit 21P connector

    -3. Substitute a known-good wheel speed sensor .

    DTC Appropriate WheelSpeed Sensor
    12-120 Right-front
    14-120 Left-front
    16-120 Right-rear
    18-120 Left-rear

    -4. Turn the vehicle to the ON mode.

    -5. Clear the DTC with the HDS.

    -6. Turn the vehicle to the OFF (LOCK) mode.

    -7. Test-drive the vehicle.

    NOTE:  Drive the vehicle on the road, not on a lift.

    -8. Check for DTCs with the HDS.

    DTC Description DTC Freeze Frame
    12-120 Right-Front Wheel Speed Sensor Circuit Malfunction    
    14-120 Left-Front Wheel Speed Sensor Circuit Malfunction    
    16-120 Right-Rear Wheel Speed Sensor Circuit Malfunction    
    18-120 Left-Rear Wheel Speed Sensor Circuit Malfunction    

    Is DTC 12-120, 14-120, 16-120, or 18-120 indicated?

    YES 

    Check for loose terminals in the VSA modulator-control unit 21P connector. If the VSA modulator-control unit was updated and the symptom/indication is still present, replace the VSA modulator-control unit .

    NO 

    Replace the original wheel speed sensor .