DTC 108-11

DTC 108-11  : Steering Angle Sensor Stuck

NOTE: Before you troubleshoot, review the general troubleshooting information .

DTCs (VSA)

1. Problem verification

   -1. Turn the vehicle to the ON mode.

   -2. Clear the DTCs with the HDS.

   -3. Turn the vehicle to the OFF (LOCK) mode.

   -4. Test-drive the vehicle.

   NOTE:  Drive the vehicle on the road, not on a lift.

   -5. Check for DTCs with the HDS.

   DTC Description	DTC	Freeze Frame
   108-11 Steering Angle Sensor Stuck

   Is DTC 108-11 indicated?

   YES 

   The failure is duplicated. Go to step 2.

   NO 

   Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting .

2. Steering angle sensor check (substitution)

   -1. Turn the vehicle to the OFF (LOCK) mode.

   -2. Substitute a known-good steering angle sensor .

   -3. Turn the vehicle to the ON mode.

   -4. Clear the DTCs with the HDS.

   -5. Turn the vehicle to the OFF (LOCK) mode.

   -6. Test-drive the vehicle.

   NOTE:  Drive the vehicle on the road, not on a lift.

   -7. Check for DTCs with the HDS.

   DTC Description	DTC	Freeze Frame
   108-11 STEERING ANGLE SENSOR STUCK

   Is DTC 108-11 indicated?

   YES 

   Go to step 3.

   NO 

   Replace the original steering angle sensor .

3. VSA modulator-control unit check (update)

   -1. Update the VSA modulator-control unit if it does not have the latest software .

   -2. Turn the vehicle to the OFF (LOCK) mode.

   -3. Test-drive the vehicle.

   NOTE:  Drive the vehicle on the road, not on a lift.

   -4. Check for DTCs with the HDS.

   DTC Description	DTC	Freeze Frame

   Is DTC 108-11 indicated?

   YES 

   Check for loose terminals in the VSA modulator-control unit 21P connector. If the VSA modulator-control unit was updated and the symptom/indication is still present, replace the VSA modulator-control unit .

   NO 

   Troubleshooting is complete. If any other DTCs are indicated, go to the indicated DTCs troubleshooting.