Gauge Control Module Connector for Inputs and Outputs
| Connector Index |
|---|
| GAUGE CONTROL MODULE CONNECTOR A (32P) |
| GAUGE CONTROL MODULE CONNECTOR B (12P) (With multipurpose camera unit) |
| GAUGE CONTROL MODULE CONNECTOR C (3P) (With display audio (7-inch screen)) |
| Terminal number | Terminal name | Description | Signal |
|---|---|---|---|
| 1 | +B BACK UP | Power source for gauge control module | About battery voltage at all times |
| 2 | Not used | --- | --- |
| 3 | Not used | --- | --- |
| 4 | GND | Ground for gauge control module | Less than 0.2 V at all times |
| 5 | CRUISE GND | Ground for ACC/cruise control combination switch | Less than 0.2 V at all times |
| 6 | Not used | --- | --- |
| 7 | Not used | --- | --- |
| 8 | ECON SW *8 | Detects ECON SW signal | With the vehicle in the ON mode and ECON switch OFF: about battery voltage With the vehicle in the ON mode and ECON switch ON: less than 0.2 V |
| MODE UP *9*11 | Detects MODE UP signal | With the vehicle in the ON mode and integrated drive-mode switch (↓) OFF: about battery voltage With the vehicle in the ON mode and integrated drive-mode switch (↓) ON: less than 0.2 V |
|
| 9 | VSA OFF SW | Detects VSA OFF SW signal | With the vehicle in the ON mode and VSA off switch OFF: about battery voltage With the vehicle in the ON mode and VSA off switch ON: less than 0.2 V |
| 10 | PARK LAMP | Detects PARK LAMP signal | --- |
*1: Without multipurpose camera unit
*2: With multipurpose camera unit
*3: With multi-information display
*4: With TPMS switch
*5: Canada models
*6: CVT
*7: With moonroof
*8: With ECON switch
*9: With integrated drive-mode switch
*10: 2/4-door
*11: 5-door
*12: CAN gateway 12P connector type
*13: CAN gateway 16P connector type
| Terminal number | Terminal name | Description | Signal |
|---|---|---|---|
| 11 | BRAKE LEVEL SW | Detects BRAKE LEVEL SW signal | With the vehicle in the ON mode and brake fluid level switch OFF: about battery voltage With the vehicle in the ON mode and brake fluid level switch ON: less than 0.2 V |
| 12 | BRAKE HOLD | Detects BRAKE HOLD signal | --- |
| 13 | Not used | --- | --- |
| 14 | CRUISE SW | Detects CRUISE SW signal | With the vehicle in the ON mode: about 0.8-4.4 V (depending on ACC/cruise control combination switch) |
| 15 | ILL-(LED) | ILL-(LED) signal | --- |
| 16 *7 | ILL-(BULB) | ILL-(BULB) signal | --- |
| 17 | IG1 METER | IG1 power source | With the vehicle in the ON or START mode: about battery voltage |
| 18 | Not used | --- | --- |
| 19 | F-CAN_H *1F-CAN A_H *2*12F-CAN C_H *2*13 | Communication line | --- |
| 20 | F-CAN_L *1F-CAN A_L *2*12F-CAN C_L *2*13 | Communication line | --- |
| 21 | FUEL GAUGE- | Ground for fuel gauge sending unit | Less than 0.2 V at all times |
| 22 | FUEL GAUGE+ | FUEL GAUGE+ signal | --- |
| 23 | LIN(START SW) *3 | Communication line | --- |
| TPMS SW *4 | Detects TPMS SW signal | With the vehicle in the ON mode and TPMS switch OFF: about battery voltage With the vehicle in the ON mode and TPMS switch ON: less than 0.2 V |
|
| 24 *5 | WASHER LEVEL SNSR | Detects WASHER LEVEL SNSR signal | With the vehicle in the ON mode and washer fluid level switch OFF: about battery voltage With the vehicle in the ON mode and washer fluid level switch ON: less than 0.2 V |
| 25 | SPORT SW *9*10 | Detects SPORT SW signal | With the vehicle in the ON mode and integrated drive-mode switch OFF: about battery voltage With the vehicle in the ON mode and integrated drive-mode switch ON: less than 0.2 V |
| MODE DOWN *9*11 | Detects MODE DOWN signal | With the vehicle in the ON mode and integrated drive-mode switch (↓) OFF: about battery voltage With the vehicle in the ON mode and integrated drive-mode switch (↓) ON: less than 0.2 V |
|
| 26 *6 | ILLUMI CANCEL | Outputs ILLUMI CANCEL signal | --- |
| 27 | Not used | --- | --- |
| 28 | Not used | --- | --- |
| 29 | Not used | --- | --- |
| 30 | B-CAN_H | Communication line | --- |
| 31 | B-CAN_L | Communication line | --- |
| 32 | GND | Ground for gauge control module | Less than 0.2 V at all times |
*1: Without multipurpose camera unit
*2: With multipurpose camera unit
*3: With multi-information display
*4: With TPMS switch
*5: Canada models
*6: CVT
*7: With moonroof
*8: With ECON switch
*9: With integrated drive-mode switch
*10: 2/4-door
*11: 5-door
*12: CAN gateway 12P connector type
*13: CAN gateway 16P connector type
(With multipurpose camera unit)
| Terminal number | Terminal name | Description | Signal |
|---|---|---|---|
| 1 | Not used | --- | --- |
| 2 | Not used | --- | --- |
| 3 | Not used | --- | --- |
| 4 | Not used | --- | --- |
| 5 | Not used | --- | --- |
| 6 | Not used | --- | --- |
| 7 | Not used | --- | --- |
| 8 | Not used | --- | --- |
| 9 | CMBS OFF SW | Detects CMBS OFF SW signal | With the vehicle in the ON mode and CMBS OFF switch OFF: about battery voltage With the vehicle in the ON mode and CMBS OFF switch ON: less than 0.2 V |
| 10 | DISTANCE SW | Detects DISTANCE SW signal | With the vehicle in the ON mode: about 0.8-4.4 V (depending on distance switch) |
| 11 | Not used | --- | --- |
| 12 | Not used | --- | --- |
(With display audio (7-inch screen))
| Terminal number | Terminal name | Description | Signal |
|---|---|---|---|
| 1 | LVDS2+ | Communication line | --- |
| 2 | LVDS2- | Communication line | --- |
| 3 | LVDS2 SH | Shield for terminals No. 1 and No. 2 | Less than 0.2 V at all times |