Body Electrical Troubleshooting - B-CAN System Diagnosis Test Mode B - Control Unit Not Communicating

Do this diagnosis if any of the control units are not communicating (NOT AVAILABLE is displayed in the HDS) as found by the B-CAN System Diagnosis Test Mode A .

1. Using the HDS, select the system that has the symptom from the BODY ELECTRICAL SYSTEM SELECT menu.

2. Select DTCs, and then check for loss of communication DTCs.

• -

  If any loss of communication DTCs are indicated, go to step 3.

• -

  If any loss of communication DTCs are not indicated, replace the body control module .

3. Do the power, ground, and communication part of the input test for the unit(s) not communicating with the HDS.