With the vehicle in the ON mode, the shift position indicator displays an improper indication, or it never displays at all

Probable cause(s)

• F-CAN communication line error
• Gauge control module defective
• TCM defective (1.5 L engine)
• PCM defective (except 1.5 L engine)
• Transmission range switch defective or out of adjustment
• Transmission range switch circuit
• Shift cable broken or out of adjustment
• Control pin broken
• Control shaft, roller, detent lever, and detent spring worn or damaged

Notes 

• Check the F-CAN communication line (1.5 L engine).
• Check the F-CAN communication line (2.4 L engine).
• Check the F-CAN communication line by using the gauge control module self-diagnostic function .
• Inspect the transmission range switch .
• Inspect the open or short in the wire between the TCM and transmission range switch.
• Check for a loose shift cable at the shift lever and the control lever .
• Check the control shaft, roller, detent lever, and detent spring for wear and damage.