No engine braking

Probable cause(s)

• TCM defective (1.5 L engine)
• PCM defective (except 1.5 L engine)
• Drive pulley, driven pulley, pulley shaft, steel belt, and pulley related parts worn or damaged
• Pulley pressure feed pipe defective
• Valve body assembly defective
• Joint pipes defective
• Solenoid wire harness worn or damaged
• Stator shaft worn or damaged

Notes 

• Check the drive pulley, the driven pulley, the pulley shafts, the steel belt, and pulley related parts for wear and damage. If there are worn or damaged, replace the transmission housing assembly .
• Check the pulley pressure feed pipe and the sealing ring for wear and damage.
• Check the valve body assembly for wear and damage.
• Check the joint pipes and O-rings for wear and damage.
• Inspect the solenoid wire harness for open and short.
• Check the stator shaft for wear and damage.