CVTF Warmer Hose Removal and Installation: Removal

NOTE: 

• Where icon is shown, further information shown below.
• Unless otherwise indicated, illustrations used in the procedure are for 1.5 L engine.

1 

Courtesy of HONDA, U.S.A., INC.

Detailed information, notes and precautions

1. Engine Coolant - Drain
2. Air Cleaner - Remove
3. Throttle Body Inlet Pipe - Remove (1.5 L engine)
4. CVTF Warmer Hose - Disconnect

   NOTE: 

   • When disconnecting/connecting the hoses, do not bend the warmer pipes excessively, or they will be damaged or deformed.
   • To prevent damage, cover the connector located under the CVTF warmer using a shop towel.
5. CVTF Warmer Hose - Connect

   Courtesy of HONDA, U.S.A., INC.

   1. Connect the CVTF warmer inlet hose and outlet hose to each bulge of the CVTF warmer lines by aligning the paint marks (A) on the lines with the paint marks (B) on the hose ends. NOTE: When disconnecting/connecting the hoses, do not bend the warmer pipes excessively, or they will be damaged or deformed. 2. Secure the CVTF warmer hoses with the clamps (C). When securing the clamps, make sure they do not interfere with the surrounding parts. Check the connector for corrosion, dirt, or oil, and clean or repair if necessary.

6. All Removed Parts - Install

   1. Install the parts in the reverse order of removal.

7. Engine Coolant - Refill