DTC Troubleshooting: P2715(CVT (TCM))

DTC P2715  : Pressure Control Solenoid D Stuck On

NOTE:  Before you troubleshoot, review the General Troubleshooting Information .

DTC(CVT)

1. Problem verification

   -1. Turn the vehicle to the ON mode.

   -2. Clear the DTC with the HDS.

   -3. Start the engine. With the brake pedal pressed, shift the transmission to N position/mode, then shift to D position/mode, and wait for at least 1 second. Release the brake pedal, and test-drive the vehicle in D position/mode at speeds 12 mph (20 km/h) or below for at least 10 seconds.

   -4. Turn the vehicle to the OFF (LOCK) mode. Repeat the test-drive in step 1-3 again.

   -5. Check for Pending or Confirmed DTCs with the HDS.

   DTC Description	Confirmed DTC	Pending DTC	Freeze Frame
   P2715 Pressure Control Solenoid D Stuck On

   Is DTC P2715 indicated?

   YES 

   The failure is duplicated. Faulty CVT lock-up clutch control solenoid valve. Replace the valve body assembly .

   NO 

   Intermittent failure, the system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.