DTC Troubleshooting: P0716(CVT (TCM))
DTC P0716 : CVT Input Shaft (Drive Pulley) Speed Sensor A Circuit Range/Performance / Input/Turbine Speed Sensor A Circuit Range/Performance
NOTE:
- Before you troubleshoot, review the General Troubleshooting Information .
- This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission.
| DTC Description | Confirmed DTC | Pending DTC | Freeze Frame |
|---|---|---|---|
| P0716 CVT Input Shaft (Drive Pulley) Speed Sensor A Circuit Range/Performance / Input/Turbine Speed Sensor A Circuit Range/Performance |
DTC(CVT)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Raise the vehicle on a lift. Make sure it is securely supported, and allow all four wheels to rotate freely.
-4. Enter the VSA maintenance mode .
-5. Run the vehicle at speeds over 19 mph (30 km/h) for at least 30 seconds. Slow down, and stop the wheels.
-6. Check for Pending or Confirmed DTCs with the HDS.
DTC Description Confirmed DTC Pending DTC Freeze Frame P0716 CVT Input Shaft (Drive Pulley) Speed Sensor A Circuit Range/Performance / Input/Turbine Speed Sensor A Circuit Range/Performance Is DTC P0716 indicated?
YES
The failure is duplicated. Go to step 2.
NO
Intermittent failure, the system is OK at this time. Check for poor connections and loose terminals between the torque converter turbine speed sensor and the TCM. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/onboard snapshot.
- Torque converter turbine speed sensor check
-1. Rotate the front wheels with the shift lever in D position/mode, and compare the Torque Converter Turbine Speed and the Input Shaft (Drive Pulley) Speed rpm in the Data List with the HDS.
Signal Current conditions Values Unit Torque Converter Turbine Speed Input Shaft(Drive Pulley) Speed rpm Are the speeds about the same?
YES
The torque converter turbine speed sensor is OK. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting, or replace the original TCM .
NO