DTC U0029-00(EPS Control Unit (Without CAN Gateway)) (2017 2018 2019)
DTC U0029-00 : F-CAN Malfunction (Bus-Off)
NOTE:
- Before you troubleshoot, review the general troubleshooting information .
- This DTC is stored by communication failure between the F-CAN line and the EPS control unit. When DTC U0029-00 is indicated, the F-CAN line has already returned to normal. Check for loose terminals and poor connections in the connectors. If the connectors are OK, clear the DTC and following this troubleshooting.
| DTC Description | DTC | Freeze Frame |
|---|---|---|
| U0029-00 F-CAN Malfunction (Bus-Off) |
DTC (EPS)
- EPS control unit communication check
-1. Start the engine.
-2. Check for communication between the EPS control unit and the HDS.
Is there communication between the EPS control unit and the HDS?
YES
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting . If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.
NO
Go to step 2.
- Open wire check (F-CAN_H, F-CAN_L lines)
-1. Turn the vehicle to the OFF (LOCK) mode.
-2. Jump the SCS line with the HDS, and wait more than 1 minute.
-3. Disconnect the following connectors.
EPS control unit connector B (6P) PCM connector A (51P) -4. Check for continuity between test points 1 and 2.
Test condition Vehicle OFF (LOCK) mode EPS control unit connector B (6P): disconnected PCM connector A (51P): disconnected Test circuit 1 Test point 1 EPS control unit connector B (6P) No. 3 Test point 2 PCM connector A (51P) No. 2 Test circuit 2 Test point 1 EPS control unit connector B (6P) No. 1 Test point 2 PCM connector A (51P) No. 1 Is there continuity?
YES
The F-CAN_H and F-CAN_L wires are OK. Check for loose terminals and poor connections at the EPS control unit connectors. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting or substitute a known-good EPS motor/control unit , then recheck. If the symptom/indication goes away with a known-good EPS motor/control unit, replace the original EPS motor/control unit .
NO
Repair an open in the wire between the EPS control unit and the PCM.