How to Use the HDS (Honda Diagnostic System)

WARNING: This page is about a different variant/trim than selected.

NOTE: Make sure the 12 volt battery is in good condition and fully charged.

1. If the system indicators stay on, connect the HDS to the data link connector (DLC)

2. Turn the vehicle to the ON mode.

3. Make sure the HDS communicates with the vehicle and the VSA modulator-control unit. If it does not, go to the DTC troubleshooting index

4. Check the diagnostic trouble code (DTC) and the freeze data (except ABS/VSA system), for all systems, troubleshoot the powertrain DTCs first. Then refer to the indicated DTC's troubleshooting, and do the appropriate troubleshooting procedure.

NOTE:

The HDS can read the DTC, the freeze data (except ABS/VSA system), the current data, and other system data.
For specific operations, refer to the HDS Help menu.