DTC U3000-51 (Real Time AWD Control Unit)

DTC U3000-51  : Control Module Programming Error

NOTE:  Before you troubleshoot, review the General Troubleshooting Information .

DTC (Real Time AWD)

1. Problem verification

   -1. Turn the vehicle to the ON mode.

   -2. Update the AWD control unit if it does not have the latest software .

   -3. Clear the DTC with the HDS.

   -4. Turn the vehicle to the OFF (LOCK) mode.

   -5. Enter the maintenance mode and start the engine .

   -6. Check for DTCs with the HDS.

   DTC Description	DTC	Freeze Frame
   U3000-51 Control Module Programming Error

   Is DTC U3000-51 indicated?

   YES 

   The failure is duplicated. Substitute a known-good AWD control unit , and recheck. If the symptom/indication goes away with a known-good AWD control unit, replace the original AWD control unit .

   NO 

   Intermittent failure, the system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.