DTC U0416-68 (EPS Control Unit)
WARNING: This page is about a different variant/trim than selected.
DTC U0416-68 : (VSA System Malfunction)
NOTE:
- Before you troubleshoot, review the general troubleshooting information .
- This DTC is stored by VSA system malfunction. If the VSA indicator on, troubleshoot the VSA system first.
| DTC Description | DTC | Freeze Frame |
|---|---|---|
| U0416-68 (VSA System Malfunction) |
DTC (EPS)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTC with the HDS.
-3. Turn the vehicle to the OFF (LOCK) mode, then to the READY TO DRIVE mode.
-4. Wait for 60 seconds or more.
-5. Check for DTCs with the HDS.
DTC Description DTC Freeze Frame U0416-68 (VSA System Malfunction) Is DTC U0416-68 indicated?
YES
The failure is duplicated. Go to VSA system troubleshooting .
NO
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting . If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.