DTC P2532-00

DTC P2532-00  : Electric Servo Brake Control Unit Power Source Circuit (IG1) High Voltage

NOTE: Before you troubleshoot, review the general troubleshooting information .

DTC (Electric servo brake)

1. Problem verification

   -1. Turn the vehicle to the ON mode.

   -2. Clear the DTCs with the HDS.

   -3. Turn the vehicle to the OFF (LOCK) mode, then to the ON mode.

   -4. Wait for 5 seconds or more.

   -5. Check for DTCs with the HDS.

   DTC Description	DTC	Freeze Frame
   P2532-00 Electric Servo Brake Control Unit Power Source Circuit (IG1) High Voltage

   Is DTC P2532-00 indicated?

   YES 

   The failure is duplicated. Go to step 2.

   NO 

   Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting . If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.

2. Electric servo brake control unit check

   -1. Check the parameter(s) below with the HDS.

   Signal	Threshold		Current conditions
   	Values	Unit	Values	Unit
   Ignition Voltage	More than 17.96	V

   Do the current condition(s) match the threshold?

   YES 

   Check the 12 volt battery , and check the electric powertrain system DTCs .

   NO 

   Check for loose terminals and poor connections in the electric servo brake control unit 22P connector. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting. If they are OK, replace the electric servo brake control unit/pedal feel simulator .