DTC P1E52-00
DTC P1E52-00 : Tandem Motor Cylinder Gearbox Stuck
NOTE: Before you troubleshoot, review the general troubleshooting information .
| DTC Description | DTC | Freeze Frame |
|---|---|---|
| P1E52-00 Tandem Motor Cylinder Gearbox Stuck |
DTC (Electric servo brake)
- Problem verification
-1. Turn the vehicle to the ON mode.
-2. Clear the DTCs with the HDS.
-3. Turn the vehicle to the OFF (LOCK) mode, then to the ON mode.
-4. Press the brake pedal several times.
-5. Check for DTCs with the HDS.
DTC Description DTC Freeze Frame P1E52-00 Tandem Motor Cylinder Gearbox Stuck Is DTC P1E52-00 indicated?
YES
The failure is duplicated. Check for loose terminals and poor connections between the electric servo brake control unit and tandem motor cylinder connector(s). Check for any authorized service information related to the DTCs or symptoms you are troubleshooting. If they are OK, replace the gearbox or the motor .
NO
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting . If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.